RaceX

Contents of shipment

The following parts are included in the kit. Click on the images to view the products shop page.

1. Step

Start by mounting 16 standoffs to the bottom plate with 16x M3*6 screws.

1. Step

2. Step

This picture shows the basic standoff locations. Some holes are left out.

2. Step

3. Step

Push the main ducts over 2 standoffs each. The ducts are symmetrical, so so there's no need to pay further attention.

3. Step

4. Step

Push the camera mount, the FPV antenna mount and the immmortal T holder over the front respectively rear standoffs.

4. Step

5. Step

Now you can push fit the topplate onto the ducts and standoffs. Make sure the orientation is correct (only one way all holes align). The Ducts slide into the topplate.

5. Step

6. Step

The next step is to mount the upper part of the ducts onto the topplate with 16x M3*8mm screws.

6. Step

7. Step

Now you can screw on the GoPro mount with 4x M3*8mm screws. The GoPro protection is held onto the mount with a velcro strap.

7. Step

8. Finish

Congratulations for building the CinematiX FPV Frame. Now you can enliven this beauty with your favourite components!

8. Finish