Contents of shipment
The following parts are included in the kit. Click on the images to view the products shop page.
The following parts are included in the kit. Click on the images to view the products shop page.
Start by mounting the standoffs to the bottomplate with four m3*10mm screws in the outer most holes.
Slide the camplates in the slots on the bottomplate. Alternatively you can push the 3D printed micro camera mount onto the front standoffs.
Push the FPV antenna and XT60 mount onto the rear standoffs.
Mount the topplate with two m3x6mm on the rear standoffs.
Screw down the camera protection with two m3*8mm screws. The cam protection is not needed if a micro camera is used.
Congratulations for building the DiveeX FPV Frame. Now you can enliven this beauty with your favourite components!
Bolt the topplate down by using 5x m3*6mm screws.
Congratulations for building the DiveX FPV Frame with Gopro mount. Now you can enliven this beauty with your favourite components!
