The diameter from motor to motor is X205/S210 mm and the frame fits 5.1“ props.
Designing, prototyping and an important part of the manufacture process has taken place in switzerland.
The RaceX frame weights about 70g naked and 80g with its 3D printed compontents.
Both front and rear arms use an interlocking system to counteract loose arms after impacts. Our system also makes sure the flight controller screws are not affected in an arm replacement.
This frame is available with X and StretchX arms as well as StretchR(ace) arms for best performance. You can also choose between 5 and 6mm arm thickness fto match your requirements!.
The design of the arms allow a very fast replacement within seconds. Only one screw has to be unbolt completely whereas the other only needs to be loosened slightly.
Although the arms are connected to each other, there is still space left in between the centerplates for the battery strap. This allows for easy and fast battery replacement.
Our unique flexible antenna mount provides a robust and sexy solution for your FPV antenna! The mount can hold AXII's, Lollipop's and similar stubby antennas.
The camera protection is designed to hold and protect a micro camera. Runcam micro Swift 2 style cameras as well as larger Runcam Micro Swift 3 are supported.
The Gopro Mount is attached to the topplate with only 2 screws. The locking mechanism allows for a fast attachement. The mount can be easily swapped for a fin!
The RaceX can also be built with a canopy. All the features above also suit the canopy version! You can put the Crossfire Race Antenna into the fin of the Pod.