Select your configuration
Contents of shipment
The following parts are included in the kit. Click on the images to view the products shop page.
The following parts are included in the kit. Click on the images to view the products shop page.
Start by mounting one arm to the bottom and middle plate using one m3*12mm (inner) and one m3*10mm (outer) screws. The m3*12mm screw is tightened into a hexagonal 10mm standoff. For the rear standoffs use the longer m3*16mm screws.
Push the 3d printed standoff extensions over the rear standoffs. These make sure the Canopy cannot slide down in a crash to prevent pressure on your electronics from the canopy.
Push the Canopy over the front and rear standoffs.
Mount the Canopy with two m3*6mm (front) and two m3*8 (back) screws and four washers.
Congratulations for building the RaceX FPV Frame. Now you can enliven this beauty with your favourite components!
The Gopro Pod uses two hex nuts, four m3*8mm and four washers. Mounting the Gopro is self-explanatory.
Start by mounting one arm to the bottom and middle plate using one m3*12mm (inner) and one m3*10mm (outer) screws and repeat this for all arms. The m3*12mm screw is tightened into a standoff.
Now you can push the camera protection and fpv antenna mount onto the front and rear standoffs.
Mount the topplate with two m3*6mm screws. if you don't want to use the Gopro mount, the frame is already assembled!.
Congratulations for building the RaceX FPV Frame. Now you can enliven this beauty with your favourite components!
push the Gopro mount down and slide it to the front. Now attach the mount with two m3*8mm screws and two washers.
Congratulations for building the RaceX FPV Frame with Gopro Mount. Now you can enliven this beauty with your favourite components!
