The diameter from motor to motor is 130 mm and the frame fits 3“ props.
Designing, prototyping and an important part of the manufacture process has taken place in switzerland.
The RiskiX frame weights about 13g naked and 21g with its 3D printed compontents.
The carbon pod takes this micro frame one step ahead! This will offer much more protection for your electronics than usual TPU pods do. Also the camera is hardmounted to carbon avoid jello and fix the angle.
The pod can be flipped open by removing only two screws for easy acess of the electronics. The top part is mounted with flexible TPU to absorb some of the kinetic energy in crashes.
The RiskiX features a stretchx layout for ultra stable flying characteristics. This frames really feels like his big 5" racing brothers!
The C arrms are designed for optimal fiber orientation and strength. Chamfered edges give this smooth feeling!
The FPV antenna is perfectly protected by a 3D printed mount. This mount also serves as a fin for use of the turtle mode! Remove the antenna is very easy and doesn't require any hardware!
The camera protection is designed to hold and protect nano cameras. It is protected perfectly inside the carbon pod and a 3d printed mount. Various camera angles are supported.
The camera is directly mounted to the carbon to avoid vibrations and allow a proper fixation. Once the angle is set, it will not easily change!
The unique battery mount holds various batteries and feautes a quick swap mechanism. It can be removed within seconds by simply rotating it by 45°.
The included Crossfire race antenna mount allows for a clean positioning of the RX Antenna.
There are slots in the back to allow a cable tie based strain relief for the XT30 connector. A capactitor can be attached in the back too.
