SkeliX

Contents of shipment

The following parts are included in the kit. Click on the images to view the products shop page.

1. Step

Start by placing the immortal T antenna in the holder and plug the holder into with the rear mount of the carbon pod.

1. Step

2. Step

Attach the skeleton with 2x M3*10mm to the bottom plate.

2. Step

3. Step

place the front and back carbon pod holders on the bottomplate next to the skeleton.

3. Step

4. Step

Push the midplate on top of the skeleton and attach it with the two M3*10mm screws. Make sure the pod holders are correctly inserted.

4. Step

5. Step

Now you can push the arms one by one in their slots and fix them with one M3*12mm each. The small midplates are the counterparts for these screws. The arms need to pushed in quite hard to make them fit properly. Often a little "right and left" movement helps to get an accurate hole overlap.

5. Step

6. Step

Push two 25mm standoffs into the pod holders.

6. Step

7. Step

Mount the camera holder in the front and the strain relief adapter in the back over each standoff.

7. Step

8. Step

Attach the carbon pod plates with 2x M3*6mm on each side.

8. Finish

9. Step

Slide 2x M3*25mm standoffs into the fin and attach the with 2x M3*6mm on each side.

7. Step

10. Finish

Congratulations for building the RangeX FPV Frame. Now you can enliven this beauty with your favourite components!

8. Finish