Babytooth
Diameter X120

X100mm

The diameter from motor to motor is 100mm and the frame fits 65mm props.

Swissness

Swissness

Designing, prototyping and an important part of the manufacture process has taken place in switzerland.

Weight

Weight

The StickiX 65mm frame weights about 6g naked and 11g with its 3D printed pod and hardware.

Thingiverse button Manual button Buyhere button

Bottomplate

The 2.5mm / 3mm bottom plate supports M2 16x16mm and M2 25.4x25.4mm hardware stacks. The motor mount pattern is 4x M2 9x9mm square and 3x M2 9mm circle (Amax motors).

Image for build height

chamfered edges

The bottom plates feature chamfered edges and countersunk screws for an ultra smooth feeling and battery protection.

Image for build height

TPU camera pod

The StickiX has a TPU camera pod on top featuring a variable tilt angle. Nano cams will fit perfectly. The pod also acts as counter thread for the m2 screws so no additional nuts are needed!

Image for build height

Carbon fiber camera pod

Another option for pods is our unique carbon fiber pod! If your going to race with your stickix, this pod helps alot in avoiding damage to the electronics. Its much more rigid but adds about 4g of weight.

Image for build height

Protective fin

The pod features a fin to protect the fpv antenna in crashes. The pod is big enough to fit the camera, a nano VTX and a nano RX (TBS).

Image for build height

LiPo quick swap

This mechanism makes swapping a lipo much simpler! rotate the battery by 45° to release the mount for ultra fast battery replacement!

Image for build height